Pulsar 77411, Руководство по эксплуатации

Страница: 6 / 85

ACCOLADE thermal imaging binoculars are supplied with a
rechargeable Li-Ion Battery Pack IPS7 which allows operation for up to
7 hours. Please remember to charge the Battery Pack before first use.
6
Charging:
Lift the lever (10) .
Fix the battery by clicking the
lever.
Install the battery (9) all the
way into the dedicated slot on
the device housing so that
element
F appears from below
(Pic.3) .
Installing the Battery Pack:
Do not leave a battery unattended while charging.
Do not charge the battery immediately after bringing the
battery from cold environment to a warm one. Wait for 30-40
minutes for the battery to get warm.
When keeping the battery for a long period, the battery should
not be fully charged or fully discharged.
Only use the charger supplied with your binoculars.
Charge the Battery Pack at a temperature from 0 °C to +45 °C.
Otherwise batter's life will decrease significantly.
Safety measures:
C
D
E
Charging
base
Battery Pack
Charger
220V socket
10 9
Pic . 3
Pic. 2
USING THE BATTERY PACK
If the indicator of the charger lights red continuously upon battery
installation, probably the battery's charge level is lower than
acceptable (the battery has been long in deep discharge). Keep the
battery in the charger for a long time (up to several hours), remove
and re-insert it. If the indicator starts blinking green, the battery is
good; if it keeps lighting red it's defective.
Do not use the battery!
Connect the Micro-USB plug of the USB cable to the port (E) of the
charger.
- once if the battery charge ranges from 0% to 50%;
If the indicator lights green continuously, the battery is fully charged.
You can remove the battery from the charger by lifting the lever
(10) .
- twice if the battery charge ranges from 51% to 75%;
- three times if the battery charge ranges from 75% to 100%;
Connect the Micro-USB plug to the charger.
Upon installation, a green LED indicator (D) on the charging base
will start to glow and begin flashing:
Lift the lever (C) of the charging base.
Remove the protective cover from the Battery Pack.
Insert the plug of the charger to the 220V socket.
Install the Battery Pack into the charging base as shown in Pic.2;
click the lever
(C).
6 5