www.pulsar.pl POE084824B
GREEN POWER CCTV PoE
7
4. Connect the network cables (Ethernet) to the PoE module: supply voltage is present only at the AUX sockets
and the cameras should be connected to them. Pin assignment of the AUX and IN sockets is shown in the Figure
4:
Fig. 4 Pin assignment of the AUX and IN connectors.
5. Use the F1/PTC1 ÷ F8/PTC8 jumpers to select the type of short circuit / overload protection of individual circuits.
Jumper in the Fx position – melting fuse activation, PTCx – PTC fuse activation.
6. If needed, the following technical connections can be made:
- FPS technical output of the PSU status – indicates the voltage loss at any of the outputs (AUX1 ÷ AUX8).
- TAMPER indicating enclosure opening.
7. Check the power supply output voltage:
- output voltage of the unloaded power supply without a battery should amount to U=54V DC.
8. Connect the batteries in series according to the color markings:
- battery output (+V): BAT+ cable/ red
- battery output (0V): BAT- cable / black
9. Check the optical indication of the PSU status: green LED light on the PoE module.
10. Close the cover after installing and checking the operation of the power supply.
3. Power supply operation indication.
3.1. Optical indication.
The PSU has 11 LED lights at the front panel:
RED LED:
•
on – The PSU supplied with 230V AC voltage
•
off – no 230V AC mains supply
RED LED:
•
on – DC voltage at the output of the switch mode PSU
•
off – no DC voltage at the output of the switch mode PSU
RED LED:
•
on – fuse failure at one of the AUX1…AUX8 outputs
•
off – no failure
GREEN LED:
•
on – DC voltage at the AUX1…AUX8 output
•
off – no DC voltage at the AUX1…AUX8 output
Additionally, the PSU is fitted with LED lights inside the enclosure – see Fig. 2 and 3:
- L
AC
red LED (Fig. 2, component 1) is permanently illuminated during normal operation (AC power ON).
No AC power is indicated by turning off the L
AC
LED.
- L
IN
green LED (Fig. 2, component 1) indicates DC voltage at the PoE module input. During normal operation (DC
supply) the LED is permanently illuminated. No DC no DC voltage at the module input is indicated by turning off the
L
IN
LED.
