Pulsar Measurement IMP Lite, Инструкция по эксплуатации

Страница: 12 / 38

IMP LITE INSTRUCTION MANUAL
12
Outdoor and Open Vessel Installation
The IMP Lite can be simply mounted on a bracket, suitable for the
application and secured using the thread located at the top of the
transducer (2"BSP/NPT).
Care should be taken to ensure that the IMP Lite is not installed in direct
sunlight, to avoid errors in the measurement of ambient temperature.
Attention should also be taken, when mounting the unit, to ensure that
strong windy conditions are avoided, wherever possible, to prevent
abnormal operation.
“L” should as a minimum be at least that as detailed in the table above
but can be greater if required .
Closed Vessel Installation
“L” should as a minimum be at least that as detailed in the table above but
can be greater if required. The IMP Lite can be simply screwed into a flange
and secured using the thread located at the top of the transducer (1.5" or
2"BSP/ NPT, dependent on model).
Where possible use a flange made of a synthetic material such as PVC, in
cases where a metal flange is used it is advisable to fit a suitable gasket
between the flange of the IMP Lite and the connection to the vessel.
IMP MODEL RANGE L = BLANKING
Lite 3
3 metres
(9.84 feet)
200mm
(0.66 feet)
Lite 6
6 metres
(19.69 feet)
300mm
(0.98 feet)
Lite 10
10 metres
(32.18 feet)
300mm
(0.98 feet)