Pulsafeeder PULSAblue 3300 Series, Руководство по установке и эксплуатации

Страница: 4 / 60

3
Pulsafeeder™ Model 3300 Controller
1 Quick Installation Sheet
1. Attach the four (4) supplied mounting feet to the back of the controller enclosure either vertically or
horizontally. Install the controller on a flat, non-vibrating surface. Do not mount the controller to a steel
object that has a large temperature change (side of cooling tower, etc). This can cause water to
condense inside the enclosure.
2. Install water meters, chemical pumps, plumbing assemblies, and sensors (see drawing on the next
page).
3. Install the provided strain reliefs with nuts, if necessary, by removing the attached black plugs and
inserting strain relief through hole. Wire the flow switch, sensors, water meters and 4-20 mA output; if
applicable (see drawing on the next page). Ensure wiring connections are correct or damage may
occur.
4. If doing a conduit installation, remove receptacles and wire pumps and bleed valve directly to the
terminals. If using a motorized ball valve, wire as per wiring instructions.
5. Plug in chemical pumps and valves to controller (unless hardwired as per step #4).
6. Apply power to the model 3300
controller, press ― BACK” twice, press ― 7” System setup, press ― 2”
Initialization, press ― 2” Whole controller, press ― 1”
Yes. After
initialization, press the ― BACK”
key
several times until you get to the main menu.
7.
Press ―1‖ Process, Press ― ENT”
. This screen allows manual control of the relay outputs to test the
chemical pumps and valves. Press ― BACK”
to return to the Process screen.
8. Calibrate the pH and conductivity. Take a sample with a handheld meter, press the CAL button, select
pH or Conductivity and type in the pH or conductivity value, press ― ENT”
. See instruction manual for
more details.
9. Program the model 3300 relays for chemical feed schemes.