PSMailers PSM10K, Руководство по эксплуатации

Страница: 19 / 24

psmailers.com • 800.464.5030
PS M ailers
™
PSM10K
19
Maintenance
Regular maintenance on the PSM10K will ensure the machine
continues to function properly and will extend the life of the
machine. Perform the following steps every 10,000 forms or
once a month:
1. Disconnect the power cord from the machine.
2. Remove both fold plates.
3. Vacuum any paper dust or toner that has accumulated on
the feed table and on the rollers.
Make sure that the power cord has been disconnected
before continuing!
4. Open the access panel in the side cover opposite the
control panel.
5. Insert the 7/16˝ socket at the end of the breaker bar (inside
the tool box) over the hex shaped end on the #3 roller
(Figure 10, page 13). This bar can now be used to rotate
the rollers.
6. Clean the stainless steel rollers with a household cleaner
to remove any accumulated toner. As you clean, use the
breaker bar to rotate the rollers so that the entire roller
surface is cleaned.
7. Clean the rubber rollers and the feed belts using a rubber
roll rejuvenator (available at your local office supply store).
Use the breaker bar to rotate the rolls and feed belt as you
clean so all the rubber surfaces are cleaned.
8. Return the breaker bar to the tool kit and replace the access
panel.
9. Replace the fold plates.
10. Make sure that the power switch is in the OFF position.
11. Connect the power cord to the machine.