PSG Wilden PS Brahma Series, Инженерия, эксплуатация и обслуживание

Страница: 12 / 32

Step 1
Before starting disassembly, mark
a line from each liquid chamber
to the corresponding air chamber.
This will assist in proper alignment
during reassembly.
Step 2
Using a 9/16” wrench, remove the
fasteners that connect the inlet
elbow to the inlet T-section.
Step 3
Using a 9/16” wrench, remove the
fastener that connects the elbow to
the liquid chamber.
T O O L S R E Q U I R E D :
• 7/32” Hex-Head Wrench
• 3/8” Hex-Head Wrench
• 7/16” Wrench
• 9/16” Wrench
• 5/8” Wrench
CAUTION: Before any maintenance or repair is attempted, the compressed air line
to the pump should be disconnected and all air pressure allowed to bleed from the
pump. Disconnect all intake, discharge and air lines. Drain the pump by turning it
upside down and allowing any fluid to flow into a suitable container. Be aware of
any hazardous effects of contact with your process fluid.
NOTE: Your specific pump model may vary from the configuration shown; however,
pump disassembly procedure will be the same.
S e c t i o n 7
P U M P D I S A S S E M B L Y
WIL-11320-E-01
10 WILDEN PUMP & ENGINEERING, LLC