PSG CADDY ALTERNA II, Инструкция по установке и эксплуатации

Страница: 18 / 108

18
VALUES (B) AND (C) CAN BE INVERTED DEPENDING ON THE POSITION OF THE COMBUSTIBLE WALL.
VALUE (C) MEETS THE MINIMUM STANDARD REQUIREMENTS TO PERFORM MAINTENANCE SAFELY.
HOWEVER, WE RECOMMEND A 30" CLEARANCE TO FACILITATE MAINTENANCE OR REPLACEMENT
OF CERTAIN PARTS.
5.4.1 FLOOR PROTECTION
- If the floor is made of non-combustible material,
no floor protector is required.
-
If the floor is made of combustible material, a non-
combustible material floor protector is required
(see table below).
FLOOR PROTECTION*
CANADA USA
A
18" (457 mm)
From door opening
16" (406 mm)
From door opening
B N/A (USA only)
8" (203 mm)
From door opening
C 8" (203 mm) N/A (Canada only)
D 8" (203 mm)
– Note 1
N/A (Canada only)
E N/A (USA only) Note 2
*Steel with a minimum thickness of 0.015" (0.38 mm) or ceramic tiles sealed together with grout. No protection is
required if the unit is installed on a non-combustible floor (ex: concrete).
Note 1:
The floor protection at the back of the furnace is limited to the furnace’s required clearance (A) if such
clearance is smaller than 8 inches (203 mm).
Note 2: Only required under the horizontal section of the connector. Must exceed each side of the connector
pipe by at least 2 inches (51 mm).