PSC QuickScan 1000, Руководство по программированию

Страница: 39 / 97

R44-2018
33
L
ABEL
T
RANSMIT
F
ORMAT
C
ONFIG
Setting Non-Symbology Specific Prefix(es)
These characters will be added to the standard label format when your host system
has specific and unique requirements for information added to the barcode label data
before it is sent to the host. Identify your specific system requirements before adding
or modifying these settings, then...
1. Look at the ASCII chart shown on page 38 and identify the ASCII
character(s) and the corresponding Hex Code(s) for the ASCII
characters you will use as prefixes.
For example, if you are going to send two prefix characters as
'STX' (start transmit) and 'SP' (Space). The ASCII chart shows
that 'STX' equals 02
hex
and 'SP' equals 20
hex
.
2. Scan the SET label.
3. Scan the SET PREFIX label on this page.
4. Scan the digits that correspond to the Hex Values.
For the example in step four, scan 0, 2, 2, 0.
NOTE
If you make a mistake, or lose your place while setting this option,
scan the END label to exit Programming Mode. The scanner will
sound an error tone (six rapid beeps) to indicate that programming
was incomplete, and the setting will remain as it was before entering
Programming Mode.
5. Scan END.
You have added a two character prefix to all label data, regardless
of label symbology, that will be added to the label data before it
is sent to the host.
SET --------------------------------------------------
-------- S
ET
P
REFIX
Go to the second page following this and scan the appropriate characters before
scanning the END label to exit programming session.