14
6. Mounting Instructions
CAUTION!
THE BATTERY TAMPER BUTTON MUST BE HELD DOWN IN THE BATTERY
COMPARTMENT BY THE BATTERY, TO ENSURE THE BATTERY DOOR WILL CLOSE.
NOTE: PLEASE ENSURE THAT BATTERY IS INSTALLED PRIOR TO MOUNTING OF HEAT ALARM.
A trim ring is provided on the back of the heat alarm. This trim ring is removed by holding the trim ring
and twisting the heat alarm in the direction indicated by the TURN TO REMOVE arrow. The trim ring is
secured to the heat alarm by a trim lever.
CAUTION ! THE COVER IS A SEALED UNIT AND HAS NO SERVICEABLE PARTS! DO NOT
TAMPER.
1. Secure a suitable junction box near the position of the heat alarm, ensure the quick connect cable
length is long enough to reach the junction box for termination to be made.
2. Connect active, neutral and switch line to the heat alarm cable using the terminal connection block
provided. Secure these terminals inside the junction box.
3. Punch out the suitable fixing holes on the trim ring and then
pull the AC connector through the centre of the trim ring.
4. Secure the trim ring to the ceiling using the fixing holes provided.
Plug the AC QUICK CONNECTOR into the back of the unit,
making sure that the locks on the connector snap into place
(see
FIGURE 6A
.)
5. Insert the 9V battery (back up) into the battery compartment.
If the back up 9V battery is already loaded in the Battery
compartment, pull out the battery pull tab. Ensure the locks
on the AC connector snap firmly into place.
6. Now mount the heat alarm onto the trim ring. Rotate the
heat alarm until the heat alarm snaps firmly into place(see
FIGURE 6B
.)
Switch on the AC power and the green AC power ‘ON’
indicator should be lit. The heat alarm is now operating
on mains power.
CONNECTOR
SQUEEZE
LOCKING
ARMS AND PULL
INSTALL
MARKS
REMOVE
FIGURE 6A
FIGURE 6B
