Configuration and Use
PowerPlay IPC-8000 and IPC-9000
4826 Sterling Drive, Boulder CO 80301
15-052-01-1-DOM-B
PH: 720.406.8946 [email protected] www.psaudio.com
©2010 PS Audio International Inc. All rights reserved.
2.
Touch the outlet again while the indicator is flashing to toggle between power on and power
off.
3.
If no changes are made the indicator will stop flashing in 10 seconds.
Note: There is no delay or IR settings associated with direct panel control. Changes made to
the power settings are immediate. Outlets set as ‘Always On’ or ‘Auto Reboot’ will only
reboot when the power state is changed via the front panel. This is by design and is
implemented to protect network critical appliances from accidental turn off.
Dimming the Display
The display may be dimmed or defeated by pressing the
SELECT
button while no outlets are
flashing. The display will cycle through on, dim and off.
Note: When the display is defeated the entire display and all lights are off. To temporarily
illuminate the unit press either of the
EDIT
buttons or touch the display panel. The display will
remain illuminated for 10 seconds.
Switch Mode
1.
Select the outlet you wish to modify by touching the corresponding outlet on the front panel.
Once selected the outlet will begin to flash.
2.
Press
SELECT
, in the LCD window you will see the Switch Mode begin to flash. We are now
ready to modify the switch mode.
3.
Pressing
EDIT UP
will cycle through the available Switch Modes as follows (
EDIT DOWN
cycles though the same list in reverse order):
SW = Switched
– The outlet will follow the state of the Power Button
DLY = Delay
– The outlet will follow the state of the Power Button after a 3 second delay
PGM = Program Delay
– The outlet will follow the state of the Power Button after a
programmed delay. Note: The Program Delay can only be altered through the web
based interfaces, the default is 3 seconds.
RBT = Reboot
– The outlet is ALWAYS ON, but may be rebooted through the web
interface
ARB = Auto Reboot
– The outlet is ALWAYS ON, may be rebooted from the web
interface, and automatically reboots when no web connection is detected for 10
minutes.
4.
To confirm and save your selection press
SELECT
while the desired setting is flashing.
