®
Operation Guide
Owner’s Reference
PerfectWave Power Plant 10
(<+06
7:
Operation
Guide
4826
Sterling
Drive,
Boulder,
CO
80301
15-056-01-1
PH: 720.406.8946 [email protected] www.psaudio.com
Rev D
©2010 PS Audio Inc. All rights reserved.
Once everything is connected you can flip the back panel power switch to power up the unit by
pressing the "I" symbol on the back panel power switch. The P10 will initialize for several seconds
before entering the home page. All zones exhibiting green receptacle icons will be outputting
regenerated AC to connected components.
Once initialization is complete, the Power Plant 10 will output regenerated AC to all zones exhibiting
green receptacle icons and will remain at the HOME SCREEN. The illuminated front-panel display is
touch-activated. By touching any of the output receptacle icons, one can toggle that zone on & off.
Upon turning off, the output receptacle icon will turn red. Below these output receptacle icons one
will find selector icons for Scope, Setup, Waveform, and Clean.
One will also notice the “connection” and “memory” status indicators. For Connection one will
see either a red or green colored “globe” symbol based on whether the unit is connected to the
network via Ethernet cable. A valid connection to the router must be established, the router must be
activated, and the DHCP server must be enabled to assign an IP address to your Power Plant 10 in
order to achieve a “green” connection
status. Memory will display either a
red or green “card” symbol based on
whether the SD Card is inserted into the
reader (on the back-panel).
In some instances, one will notice a third
status indicator which is a circle with
the image of an AC plug inset. During
typical operation, this status indicator
will not be present. However if the
Power Plant 10 is outputting 90% of
its full potential, the status indicator will
appear in orange color. If the Power
Plant 10 is outputting 100% of its potential, the status indicator will be red in color. Both of these
status indicators are warnings that the P10 is being pushed too hard, and that a smaller load will be
necessary. If the P10 goes over 100% of its capable output, it will shut down.
How to Turn It On
Home Screen
7
