Prusa Research Original Prusa i3 MK2S 1.75mm, Руководство пользователя

Страница: 4 / 67

Table of contents
About the author 3
Table of contents 3
2 Product details 5
3 Introduction 6
3.1 Glossary 6
3.2 Disclaimer 7
3.3 Safety instructions 7
3.4 Licenses 7
4 Original Prusa i3 MK2S printer 8
5 Original Prusa i3 MK2S printer kit 9
6 First steps 10
6.1 Printer unpacking and proper handling 10
6.2 Printer assembly 11
6.3 Setup before printing 11
6.3.1 Calibration flow and wizard 11
6.3.2 PEI print surface preparation 13
6.3.3 Increasing the adhesion 14
6.3.4 Selftest (kit only) 14
6.3.4.1 Selftest error messages and resolution (kit only) 15
6.3.5 Calibrate XYZ (kit only) 15
6.3.5.1 Calibrate XYZ error messages and resolution (kit only) 17
6.3.5.2 Y axis alignment (kit only) 19
6.3.6 Calibrate Z 19
6.3.7 Mesh bed leveling 20
6.3.8 Loading the filament into the extruder 21
6.3.8.1 Unloading the filament 22
6.3.9 First layer calibration (kit only) 22
6.3.9.1 Launching first layer calibration directly from menu - preffered way 22
6.3.9.2 Launching first layer calibration from SD card - deprecated 22
6.3.9.3 Adjusting z-height during the calibration 22
6.3.9.4 Bed level correction (kit only) 24
6.3.10 Fine-tuning the first layer 24
6.3.10.1 Print Prusa logo 24
6.3.10.2 Check probe height (kit only) 24
7 Printing 26
7.1 Removing objects from the printer. 26
7.2 Printer Control 27
7.2.1 LCD screen 27
7.2.2 Print statistics 28
7.2.3 Silent vs. Hi-power mode 28
7.2.4 Factory reset 28
7.2.5 SD card sorting 29
7.2.6 Testing if file (.gcode) is complete 29
7.2.7 LCD layout 30
4