PRÜFTECHNIK VIB 5.300 EX Series, Руководство по эксплуатации

Страница: 157 / 172

6-11
VIBXPERT 11.2010
Appendix - VIBCODE
Coding ...
... or, "How are the measurement locations in the data base linked to the
measurement locations onsite on the machine?"
The coding of the “mechanical” measurement locations is defined in
the measurement location data base using the OMNITREND software
and stamped into a special plastic ring using a tool. The coded ring is
installed on the machine together with the measuring pin. This forms
the link between the data base and the machine.
VIBCODE concept
... or, "What is the difference between a route and a pool?"
A machine park contains many VIBCODE measurement locations.
However, not all measurement locations are measured with the same
frequency since they are assigned different roles in the data base.
Thus, the VIBCODE concept is structured as follows:
A: VIBCODE route
VIBCODE measurement locations at which measurements are taken
regularly are part of a route. Because each route is created for a
particular purpose (e.g. weekly inspection), it only contains a certain
subset of all VIBCODE measurement locations. VIBCODE features
automatic measurement location recognition so that the measure-
ment locations can be visited in any order.
B: VIBCODE pool
A “pool” contains additional measurement locations that are mea-
sured on a route only if there is a special need. Pool measurement
locations are loaded into the data collector together with the
corresponding route.
C: Unknown VIBCODE measurement location
If the VIBCODE sensor is connected to a measurement location that is
contained neither in the current route nor in an associated pool,
VIBXPERT interrupts the route. A measurement can only be per-
formed in the ‘Multimode’ (see also next page).
Route
Pool
A C B