PRÜFTECHNIK VIB 5.300 EX Series, Руководство по эксплуатации

Страница: 91 / 172

3-37
VIBXPERT 11.2010
Recording
The number of results depends on the
available memory space
The configuration screen appears (see below):
Start conditions
I
MMEDIATELY
: The recording starts immediately (MENU -> Start).
S
TART IN
: Recording begins after a set period (0 s ... 23:59:59 h).
S
TART AT
: The measurement recording begins at the set time (time,
date) or when the set rpm is reached (0 ... 1000 Hz); the rising or
falling edge can be selected. For an rpm-controlled measurement,
the task must contain an rpm measurement.
D
ELAY
: Specifies the time/rpm change between two measurements.
Stop conditions
C
OUNTER
: The measurement is ended when the entered number of
results has been measured (1 ... 10000).
R
UN FOR
: Recording duration (0 s ... 23:59:59 h).
S
TOP AT
: The measurement stops at the specified time or when the set
rpm is reached (0 ... 1000 Hz); the rising or falling edge can be
selected.
M
ANUAL
: The measurement stops when the memory card is full or
when the ESC key is pressed.
Further settings
S
WITCH OFF BACKLIGHT
: To save power when operating the device during
recording, the display illumination can be switched off perma-
nently. This option is independent of the settings in the device
setup (P. 2-13).
T
RIGGER
: This option is only available if the measurement is triggered
via the signal level (see ‘Trigger’, p. 3-22).
‘Individual’: The trigger condition is only considered before the
first measurement.
‘Multi’: Only start each measurement when the trigger condition
has been met.
T
ARGET FILE
: The results and the configuration settings are saved in a
file. It is not possible to add multiple recording files.
The start, stop and delay conditions
can be independently controlled ac-
cording to time or rpm. For example,
recording can be set to start at a
certain time, but the next measure-
ments only take place after a certain
change in the rpm. Recording configuration