Proxxon Thermocut, Руководство пользователя

Страница: 7 / 28

- 7 -
Note:
It is normal that the wire extends somewhat after
being heated for the first time. Stretch the wire slightly
by the first heating and tension it again. The wire will
now retain its length.
11. Adjust the temperature with the regulator 2. The table on
the front of the device serves as a guide. The best way to
find the ideal temperature is to try different temperatures
yourself. For simple, straightforward cuts you use a high
temperature, for complicated shapes a lower temperature.
Please note that too high temperatures will cause untidy
edges.
12. Now move the foam plastic through the wire with a light
pressure and even speed. Be aware that too high pressure
in the direction of the cut when cutting complicated shapes
will tend to bend the wire.
Mitre cutting
Mitre cutting can be done in two ways with the THERMOCUT:
by adjusting the spool carrier or with the adjustable angle stop.
Adjusting the spool carrier: loosen the screws 1 and 2 (Fig. 3)
and select the required mitre angle by sliding the spool carrier.
Tighten the screw 1 again and tension the wire as usual.
Note:
Adjusting the spool carrier will lengthen the heated
part of the wire and thus increase the electrical
resistance. The temperature must be adjusted
accordingly.
Working with the stop: Select the required mitre on the angle
stop and secure the adjustment with the screw 1 (Fig. 4). Move
the extension 2 so that you can pass the cutting wire without
difficulty. Press the foam plastic against the stop and guide the
stop along the slot 3.
Note: The stop can be fixed for parallel cutting. Turn the screw
1 (Fig.5) to clamp the stop in the slot. Guide the foam plastic
past the cutting wire along the stop.
Important hints:
– When cutting double mitre (e.g. roof), don’t remove the cut off
after the first cutting. Use it as an underlay for the second cut.
– The wire has a higher temperature at the exit side of the foam
plastic, which may cause surface melting. To prevent this the
wire can be cooled by blowing on it.
– Small sections of long profiles can best be cut by laying a
waste piece 1 (Fig. 6) between the stop and the work piece
and then cutting against the stop. The cutting wire then cuts
into the waste piece and the edges remain clean.
– You can make a simple device yourself for cutting circular
segments. Fix a drawing-pin at the centre of the required
circle on the working table with a piece of tape. Fix the
workpiece onto the pin and turn the workpiece around the pin
(Fig. 7).
– The cutting wire normally breaks above the guide bushing.
Insert the wire a few centimetres further in the lower wire
guide and fasten it again at regular intervals to prevent wire
breaks.
Cleaning the device
Clean the wire and the bushing regularly to prevent unneces-
sary evaporation of foam plastic residue. Caution: First switch
off the device!
Disposal:
Please do not dispose of the device in domestic waste! The
device contains valuable substances that can be recycled. If
you have any questions about this, please contact your local
waste management enterprise or other corresponding municipal
facilities.
EC conformity declaration
We declare with sole responsibility that this product meets the
provisions of the following EC guidelines:
• EC low voltage guideline 73/23/EEC / 93/68/EEC
• DIN EN 60335-1 / 07.2003
• DIN EN 60335-2-45 / 06.2003
• EC-EMC guideline 89/336/EEC
• DIN EN 55014-1 / 09.2003
• DIN EN 55014-2 / 08.2002
• DIN EN 61000-3-2 / 12.2001
• DIN EN 61000-3-3 / 05.2002
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Business area Product safety