51
I can't find another computer on the
wireless network.
1. Confirm that the other computer is
listed in the Symphony Network Map in
the Maestro tool.
2. Test the strength of the wireless con-
nection between the two computers
from within the Maestro tool. The com-
puters may be too far apart.
3. Confirm that you successfully logged
onto the network. If you are unsure, go
to the Start Menu and log off the current
user to bring up the Network Logon
prompt.
4. Use Microsoft's Find Computer util-
ity to locate the computer on the net-
work.
Which Ethernet port should I use to
connect the Base Station to a cable
modem?
In general, an Ethernet port on a cable
modem, DSL modem, and ISDN router
will have the same pinout as a cabling
hub. In this case, connect an Ethernet
cable to the Base Station’s Port I. How-
ever, if the Link LED does not light up
on the Base Station when it is connected
to another Ethernet device, try connect-
ing the cable to Port II.
The Link LED on the back of the Base
Station is not on.
Try connecting the cable to both ports
of the Base Station in succession. If the
Link LED does not light up when con-
nected to either port, try another Ether-
net cable; your cable may be damaged.
The Base Station’s Power Indicator
LED is blinking on and off.
The Base Station is in the middle of
upgrading its firmware; be patient while
it completes the upgrade process.
How do I know if the Base Station’s
Ethernet port is operating at 10 Mbps or
100 Mbps?
Watch the Base Station’s Ethernet LED.
It blinks green when there is 10 Mbps
activity and yellow when there is 100
Mbps activity.
Symptom/Question
Possible Solution/Answer
