Configuration
Tsunami MP.11 5012/5054-SUI Installation and Management
System Parameters
59
•
System Name:
This is the system name for easy identification of the SU. The System Name field is limited to a length
of 32 bytes. Use the system name of a BSU to configure the Base Station System Name parameter on an SU if you
want the SU to register only with this BSU. If the Base Station System Name is left blank on the SU, it can register
with any Base Station that has a matching Network Name and Network Secret.
•
Country:
Upon choosing a country/band, the Dynamic Frequency Selection (DFS) and Transmit Power Control (TPC)
features are enabled automatically if the selected country/band has a regulatory domain that requires it. The Country
selection pre-selects and displays only the allowed frequencies for the selected country/band.
Click
Configure
>
Interfaces
>
Wireless
to see the channel/frequency list for the selected Country.
NOTE:
If
All Channels 5 GHz
is selected from the
Country
drop-down menu, any channel in the 5 GHz range are
displayed for manual selection.
NOTE:
Units sold only in the United States are pre-configured to scan and display only the outdoor frequencies
permitted by the FCC. No other Country selections, channels, or frequencies can be configured. Units sold
outside of the United States support the selection of a Country by the professional installer. If you change the
Country, a reboot of the unit is necessary for the upgrade to take place.
For a non US-only device, the default country selected is
United Kingdom (GB)
.
Note the following:
–
The channel center frequencies are not regulated; only the band edge frequencies are regulated.
–
If, before upgrade, US was selected as a country for a non US-Only device (which is an incorrect configuration),
the country is changed automatically to United Kingdom upon upgrade.
for a list of country codes.
•
Location:
This field can be used to describe the location of the unit, for example “Main Lobby.”
•
Contact Name
,
Contact Email
, and
Contact Phone:
In these fields, you can enter the details of the person to
contact.
•
ObjectID:
This read-only field shows the OID of the product name in the MIB.
•
Ethernet MAC Address:
This read-only field shows the MAC address of the Ethernet interface of the device.
•
Descriptor:
This read-only field shows the product name and firmware build version.
•
Up Time:
This read-only field shows the length of time the device has been up and running since the last reboot.
•
Mode of Operation:
This drop-down menu is used to set the unit as a
bridge
(layer 2) or as a
router
(layer 3). See
for more information.
Bridge and Routing Modes
Bridge Mode
A bridge is a product that connects a local area network (LAN) to another LAN that uses the same protocol (for example,
Ethernet). You can envision a bridge as being a device that decides whether a message from you to someone else is
going to the local area network in your building or to someone on the local area network in the building across the street.
A bridge examines each message on a LAN, passing those known to be within the same LAN, and forwarding those
known to be on the other interconnected LAN (or LANs).
In bridging networks, computer or node addresses have no specific relationship to location. For this reason, messages
are sent out to every address on the network and are accepted only by the intended destination node. Bridges learn
which addresses are on which network and develop a learning table so that subsequent messages can be forwarded to
the correct network.
Bridging networks are generally always interconnected LANs since broadcasting every message to all possible
destination would flood a larger network with unnecessary traffic. For this reason, router networks such as the Internet
use a scheme that assigns addresses to nodes so that a message or packet can be forwarded only in one general
direction rather than forwarded in all directions.
Содержание 5012-SUI
Страница 1: ...Tsunami MP 11 Installation and Management Guide Model 5012 SUI Model 5054 SUI Version 4 0 0...
Страница 41: ...System Overview Tsunami MP 11 5012 5054 SUI Installation and Management Virtual Local Area Networks VLANs 41...
Страница 78: ...Configuration Tsunami MP 11 5012 5054 SUI Installation and Management SNMP Parameters 78...
