Proware SN-3163S3H-QX, Руководство пользователя

Страница: 28 / 237

SAS / SATA II NAS System
28 User Manual
Chapter 3 Getting Started with the NAS System
3.1 Connecting the NAS to your Network
1. Attach network cable to the R-Link port. Connect the other end to your network
hub or switch. Alternatively, you may use the Monitor port and connect the serial
cable from the Monitor port to any available COM port of a PC.
2. Attach network cable to the Ethernet port LAN0. Connect the other end to your
network hub or switch. You may also connect the other Ethernet port if needed.
3.2 Powering On
NOTE: If other JBOD subsystem(s) or RAID subsystem, with or
without JBOD subsystem(s) connected in daisy-chain, are to be
connected to the SAS Expansion Port or to the SAS HBA Port
respectively, the JBOD subsystems or RAID subsystem (and its
JBOD subsystem(s) must be powered on first before the NAS. This
is to detect the disk drives from the JBOD subsystem or the
volumes from the RAID subsystem. Refer to Section 3.4 for more
information.
1. Plug in all the power cords into the AC Power Input Socket located at the rear of
the NAS system.
NOTE: The NAS system is equipped with redundant, full range
power supplies with PFC (power factor correction). The system will
automatically select voltage.