Proware SN-3163S3H-QX, Руководство пользователя

Страница: 139 / 237

SAS / SATA II NAS System
User Manual 139
Network Adapter:
The Network Adapter section consists of the Adapter List and the Configuration section.
The Adapter List is the list of available Ethernet ports in the system. The number of ports
might be two or three depending on different models.
Adapter List:
Lists the available Ethernet adapters.
Configuration:
‹ Use Dynamic IP Configuration (BOOTP/DHCP) - If checked, this specifies
that this network connection will dynamically obtain an IP address from a
Dynamic Host Configuration Protocol (DHCP) server or from a Bootstrap Protocol
(BOOTP) server.
‹ Enable this adapter on boot – If enabled, this adapter will be active when
proNAS starts up.
‹ Enable default gateway on this adapter - If checked, the default gateway will
be enabled in this adapter. A default gateway is a local IP router that is used to
forward packets to destination beyond the local network. Only one default
gateway can be enabled in a certain time.
‹ Device - Displays the type of Network Interface Card.
‹ IP address – Shows the current IP address. To edit IP address, enter the new IP
address.
‹ Gateway – Shows the current gateway IP address. To edit, type in a new
gateway IP address.
‹ Subnet mask – Shows the current subnet mask setting. To edit, type in the new
subnet mask number.
‹ MTU – The MTU size (Maximum Transmission Unit) in bytes. To modify the MTU
size for this interface, enter the new MTU size.
Network Trunking
ProNAS provides the network trunking/bonding function. Ethernet bonding refers to
aggregating multiple Ethernet channels together to form a single channel.
NOTE: It is necessary that the network switch supports the type of
trunking mode that will be used. Otherwise, the network
connections may be unstable.