ProVisual PTZ-501C – PTZ Keyboard Controller Manual
www.provisualusa.com
12 |
P a g e
Figure 4.2.2-2
While enter the dome limit setting menu, move the dome to the suitable position, and press
【
Enter
】
to save and will show “Success" and
back to previous menu.
Select the item 2 to set the Right limit, and do the same as the left limit setting,
Back to the menu and press
【
3
】
to operate the Run Scan.
Warning
：
4.2.3 - Pattern Setup
Enter the menu as the picture (4.1.1-1)
Press
【
2
】
enter the dome setting menu as the picture (4.2.1-1);
And then press
【
3
】
enter the pattern setting as picture 4.2.3-1 show
.
Figure 4.2.3-1
After enter the menu, the system need input the pattern information you want, you can put in the NO1~4 and
Press the
【
ENTER
】
. The mouse will skip to the next item auto to set the second patter you need. If you already have it, you can skip it
and select the
【
3
】
to run the pattern directly.
Pattern setting
：
After enter the pattern setting menu, move the dome do the suitable position and press the
【
1
】
to start record the scan
track. The screen will display “Start ……, like the picture4.2.3-2. Press “0” to finish the scan record and the screen will show “Success”
and back to the previous menu.
Figure 4.2.3-2
Warning
：
4.2.4 - Tour Setup
Press
【
2
】
enter the dome setting menu, as the picture 4.2.1-1 show,
And then press
【
4
】
enter the tour setting as the picture 4.2.4-1 show.
Figure 4.2.4-1
After enter the menu, you need input the TOUR information, the range you can put is 1~6, and press the
【
ENTER
】
. The mouse will
Press ENTER sure
Press PREV to back
After entering the dome scan menu, the keyboard can directly control the dome and lens
control zone also can control the dome’s lens.
。
1. Pattern num:
2. Set pattern
3. Run pattern
Press 1 to start
Press 0 to start
Press PREV to back
After entering the dome pattern, the keyboard can directly control the dome and lens control
zone also can control the dome’s lens.
1. Tour num:
2. Insert preset
3. Run tour
