BTP-2100E USER MANUAL
3)
THP test page can show if the THP status is in good status.
Set paper type
Before the print, set the paper type in driver correctly and pay attention
to the relation between paper type and sensor in paper load. Select
paper type according to the table as below:
Paper type in the
driver
Actual paper type
Sensor type
Continuous paper
Continuous strip paper
Reflection sensor
Non-continuous marked paper
Reflection sensor
Non-continuous Perforated
paper
Black mark paper
Non-continuous edge-gap
paper
Reflection sensor
Label
Non-continuous label paper
Transmission sensor
Table 2.6.1
Checkout mark
A Manual checkout function
1)
Turn off the printer.
2)
Load the media properly.
3) Hold down “Pause” key and turn power switch to “
－
” position.
After the buzzer gives one sound, release “Pause” key, the printer
shall feed paper and start the checkout.
4)
If checkout is successful, the printer enters standby status. If it fails,
the printer shall alert, then please check:
¾
If media is loaded correctly.
¾
If paper type loaded is consistent with current paper type of
the printer (via a self-test page printed)
Notice:
In the following cases, the media needs to be verified before the
print:
It is the first time to mount and use the printer.
The printer is used again after a long idle time.
Replace new type of paper roll.
First time to use it after cleaning the sensor.
Fails to identify marks in effect during the print.
Operation environment of the printer is changed greatly.
B Auto Checkout functions
Before starting the print job, the printer shall compare the parameter
set by customers with current parameter of the printer to decide if it
shall initiate the checkout with the process as below:
- 12 -
