BTP-2100E USER MANUAL
(see figure 2.11).
Figure 2.11
Notice:
z
Select the print mode: To select thermal transfer mode, you
need to mount ribbon. To select thermal mode, no need to
mount ribbon.
z
In normal condition, ribbon width should be bigger than the
paper width.
z
During this mount, the ribbon should not be cockled or
damaged.
Starting the printer
Turn on the printer and self-test
1) Be sure that power adapter and communication cable are connected,
then turn on the printer power switch.
2) The printer starts self-test. After this self-test, buzzer shall sound one
time.
3) If the printer sets the media type as non-continuous paper and allows
Auto paper load, it shall automatically load paper to the print position.
Notice:
If the printer cannot start or work normally, please contact
with our distributors or manufacturer.
Print a self-test page
The self-test page includes the printer configuration sample and TPH
test sample.
1) Turn off the printer power and load the media. Hold down “Feed”
key and turn power switch to “
－
” until the buzzer gives one sound.
The printer shall feed paper and print a self-test page after
releasing “feed” button. (Self-test page sees appendix 1).
2)
The configuration describes the current settings of the printer.
- 11 -
