21
Rader Gun Interface
Select Rader Gun
Set Baudrate
Exit
Select Radar Gun
Select Radar Gun submenu lets you select the radar
gun that you want to use with the VCR. To access the
radar gun interface place cursor in front of Radar gun
interface and press the “F.F” button. The following menu
will pop up on the screen:
S ele ct R a d e r G un
N o ne
D ec atur G e ne sys
D ec atur H unte r
G o ld e n Eagle
LTI 2 0 .2 0
M P H P ytho n
M unic ip al TS - 4
R ap id F ire P lus
R G 2 R S
Exit
NONE
This is the default setting, and the setting you should
leave it chosen you do not have a radar gun connected
to the VCR.
Input Voltage
The VCR can display the input voltage on the screen.
You can turn off or on the voltage message from the
display settings. A “LOW VOLTAGE” message will start
flashing on the screen if the input voltage is less than
9V. If the voltage is less than 9 V and the cassette is
out then a “CASS OUT” message will start flashing on
the screen. The VCR will not accept a tape if the input
voltage is less than 9V. Follow the steps below to turn
the voltage display on or off.
1
Under the main menu place the cursor in front
of Display Setting and press the “F.F” button.
2
Now place the cursor in front of Input Voltage
and press the “F.F.” button.
3
Press the “+” or “-” button to select “ON” or
“OFF”.
4
Exit all of the menus to activate your selection.
Temperature
A built in temperature sensor tracks the internal tem-
perature of the VCR . You can view the internal tem-
perature by enabling the temperature display in the dis-
play setting menu. If the temperature goes higher than
90 F then the Fan Output is activated (active low). If
the temperature goes lower than 40 F then the Heater
output is activated (active low). If the temperature goes
lower than 32 F then the VCR will be turned off. Follow
the steps to enable the temperature display on the
screen.
1
Under the main menu place the cursor in front
of Display settings and press the “F.F.” button.
2
Place the cursor in front of Temperature and
press the “F.F” button.
3
Press the “+” or “-” button to select “ON” or
“OFF”.
4
Exit all of the menus to activate your selection.
RADAR GUN INTERFACE
The radar gun interface submenu displays the choices
of the manufacture of the radar gun. This menu also
lets you set the baud rate between the interface and the
radar gun. The following menu will appear if you select
the radar gun interface from the main menu.
