16
Programming
ACCESSING MAIN MENU
To access the on screen programming press the “STOP”
button of the remote control for about 5 seconds. The
following programming menu will be appear on the moni-
tor of the control head LCD.
M ain M enu
Set Time/Date
Titler
M essages
Record Setting
Display Setting
Rader Gun Inteface
M aster Reset
Exit
TIME & DATE SETUP
An Internal clock generates the time and date that is
super imposed on the LCD display. After the clock is
set, the date and time modes are displayed on the moni-
tor screen (live picture).
Display Time & Date on Screen
1
Under the “Display Time & Date” menu place
the cursor in front of T/D display and press the
“ F.F” button of the remote control.
2
Press the “+” or “-” button to select “ON” or
“OFF”.
3
Press the “F.F.” button again to make your
selection.
4
To exit out of the Display Time & Date, place
cursor in front of “Exit” and press the “F.F.”
button.
5
Exit out of all of the menus to activate above
your selection.
Time / Date
T/D Display ON
Time Format 12 Hour
Date Format MM/DD/YY
Set Time/Date
Reset Time/Date
Exit
Selecting Time Format
1
Place the cursor in front of “Time Format” and
press and release the “F.F” button.
2
The cursor will start blinking.
3
Now push the “+” or “-” button to select either
the “12” or “24” time display modes.
4
After selecting the desired mode press and
release the “F.F.” button.
5
Exit all of the menus to activate your selec-
tion.
In this section we discuss some of the powerful pro-
gramming features of the “in trunk system”. The pro-
gramming mode can only be accessed by using the IR
remote control. The following table shows some of the
IR- Remote button functions used in the programming
mode.
Things to Note:
“STOP”-
Press and hold the remote control’s “Stop”
button for 5 seconds to access the mail menu
“F.F.”
-
Press this button to enter or exit any selection
“+”
-
Press this button to move the cursor up
“-”
-
Press this button to move the cursor down
