CRW 200 Service Manual
10/13
4.6. The device rebuilding.
4.6.1
•
Grease the main shaft (1) in
the pointed place.
•
Mount the shaft (1) into
casing.
•
Mount the washer (2) and
Z20 snap ring (3).
4.6.2
•
Mount the parallel key (4)
into shaft's slot.
•
Mount the brake set (5) onto
shaft.
•
Mount the Z20 snap ring (6)
onto shaft.
4.6.3
•
Set the locking pin set (7)
into casing hole.
•
Set the winch set (8) into
casing, screw preliminary
the locking pin (7) set to
winch set (without
tightening) and screw 3 M6
screws (9).
•
Tight the locking pin set (7)
screwing connection to
winch set (8).
4.6.4
•
Turning with the main shaft, position
the shaft's groove (9) opposite the
retracting spring ending (10) so that
inserting of the spring ending into
groove is possible.
•
Put on the retracting spring cover set
(11) on the base. Pay attention to
insert the ending (10) of the retracting
spring into shaft's groove (9) and the
hole (12) on the winch set body (13).
•
With the aid of Torx type wrench T25
screw 6 x M5 bolts (14).
4.6.5
•
Mount the parallel pin (15);
spring-G (16) and M10
screw (17) into cover's hole.
•
Mount the crank nut (18)
onto crank shaft.
grease
1
2
3
4
5
6
7
9
8
7
grease
10
9
14
13
12
11
grease
15
16
17
18
