19
CP - OPTI
Problems and Solutions
Advice on Machine Errors
Machine does not switch on
•
Ensure that electrical plug is firmly inserted into socket.
•
Ensure that electrical socket has power supply by testing with an appliance
(e.g. tablelight).
Film will not feed in but the dryer fan works
•
Place cover firmly on machine, ensuring that the cover switch on the right
front side has been activated.
Machine does not start automatically
•
Film switch left side at the infeed has not been pressed down. Feed in the film
to activate the switch.
Developer temperature too low
•
The temperature dial is set between two positions.
Replenishment pump does not pump
•
Check whether the replenishment containers are full and that the end of the
suction pipe is positioned under the liquid level.
•
Check whether there is air in the replenishment pipes. If this is the case, then
check the pipe connections.
Rinsing water does not flow
•
Open water inflow tap.
•
Water pressure in the water system is too low: Minimum pressure 2 bar
(29 psi).
Water tank overflows
•
Water drainage hose (overflow) is bent. The hose end should be positioned
above the drainage level in the syphon (see diagram on page
7
).
•
Check water drainage in the tank and hose for blockage and pollution. The
drainage hoses should have a constant fall.
The film does not transport correctly
•
Film is fed in and gets caught in the machine: Check the positioning of the
racks in the machine and make sure that the latches are closed.
Important notes:
Ensure correct seating of roller racks; keep the lock closed at
all times.
Don’t operate processor with empty replenishment tanks.
After a long machine shut down check bath level and refill if
necessary.
Содержание FI-75 MAMMO
Страница 2: ...1 CP OPTI EU Declaration of Conformity EU Declaration of Conformity ...
Страница 35: ...34 CP OPTI Electric Diagrams ...
Страница 36: ...CP OPTI 35 Electric Diagrams English ...
Страница 37: ...36 CP OPTI Electric Diagrams ...
