22 MARK68AF1001 Rev 2
Equipment Operation and software
Operating Modes:
There are 4 different operating modes for this equipment.
Standby Mode
The Massage bed is in an idle state, it is connected to the power but is currently not in use.
The pump is not turned on at this point. While in Standby mode you can change to Massage
mode by starting a session or go into service mode by entering into the parameters.
Massage Mode
The massage bed is in use and the pump is on. The session time is counting down and can
be stopped, paused or features can be changed in the computer screen.
Cool down Mode
The massage bed has finished the session and now will start a mandatory cool down if
the temperature is more than 2 degrees above the set temperature. During this time the
cool down time will be displayed in the computer screen and the buttons have no function
if pressed. The bed must complete the cool down before being able to enter into any other
operating mode.
Service Mode
In service mode the massage bed parameters can be changed and the bed can be configured
as needed.