Prostat PBT-531, Руководство пользователя

Страница: 17 / 20

15
06 PDS-510 POWER SUPPLY
The PDS-510 is also equipped with a power supply that can be used to charge UNGROUNDED items
from 0 to 4,000 volts. In order to use the power supply:
1. Make sure that the PDS-510 is connected to AC ground using one of the unit’s grounding
ports.
2. Connect a cable to the Power Supply output port of the PDS-510.
3. Adjust the power supply’s voltage to the desired level.
4. Using the open end of the cable contact the cable to the item that requires charging.
5. After charging the item of interest, turn the PDS-510 off to prevent shocks and damage to the
PDS-510. Care must be exercised to prevent shocks to personnel.
07 CHARGING THE BATTERY
The PDS-510 is supplied with a universal charger in order to charge the battery. In order for the
batteries to charge, make sure the Main Power switch is ON. The batteries will not charge if the Main
Power is OFF.
The charger comes with several adapters for different outlets.
08 TROUBLESHOOTING
PicoScope 6 does not recognize my device:
1. Verify that the LED light is lit on the front of the oscilloscope. There should be a red light.
2. Check the USB cable (ensure it is the supplied Pico blue USB cable). Try a different USB port.
3. If using a device with an external power supply, disconnect and reconnect the power supply.
4. If using a desktop PC, consider using the rear USB ports.
5. If using multiple USB devices on a PC and the PicoScope does not have an external power
supply, consider using a powered USB hub.
6. Device Manager – confirm that the device is listed either under Pico Technology Instruments
(or Universal Serial Bus controllers for older models such as the PicoScope 2205).
7. Confirm that the operating system is Windows XP (SP 3), Vista, 7, 8, 10 or 11 (32 or 64-bit).