ProSoft ProLinx Wireless 6201-WA-MNET, Руководство по установке

Страница: 8 / 48

6201-WA-MNET ♦ ProLinx Wireless Introduction
High Speed Wireless Modbus TCP/IP Gateway
Page 8 of 48 ProSoft Technology, Inc.
June 27, 2007
1.2 Using the Sample ProSoft Configuration Builder Files
The sample application uses two 6201-WA-MNET modules to establish wireless
communications between a Primary Client at a main site and a Server located at
a remote site. One MNET module is configured as a Client. The remote Server is
attached to this Client. The second module is configured as a Server at the same
site as the Primary Client. The following diagram illustrates this application.
In this example, the following is assumed:
ƒ A third-party primary Client needs to communicate with 4 Servers
ƒ One of the Servers is remote
ƒ
The application uses two ProLinx 6201-WA-MNET modules to establish
communication between the primary Client and the remote Server
ƒ
The module's radio communication parameters are preset and configured to
pass up to 1200 words in either direction
ƒ One MNET (Server) is connected to the Primary Client
ƒ One MNET (Client) is connected to the remote Server
You can use this guide in one of two ways. First, you can use it as a learning tool
to see how the PCB files make the sample application work. You can also follow
along with the example and modify the configuration files as you go along.
Whether you are configuring your modules on the fly or just reading through to
understand how to use the sample application, there are steps that you must
perform even if you are not yet configuring any modules to suit your own
application.