Start Here
RLXIB-IHW-66
♦
802.11a, b, g
User Manual
Industrial Hotspot
ProSoft Technology, Inc.
Page 13 of 109
May 18, 2009
6
Click Apply Changes to save the master radio settings.
To cancel the settings and start over, click the Cancel Changes button before
you click Apply Changes. After they are configured, master radios are
preceded by an "M" in the utility window list.
Note:
The text shown in yellow at the bottom of the window indicates the status of changes you
have made to the configuration.
If the text shows "Changes not saved", click Apply Changes to save your settings.
If the text shows "Changes not saved; Will disrupt X s", you can click Apply Changes, however
the network will be disrupted temporarily while the changes are applied. The value of "X"
indicates the number of seconds the network will be offline.
7
Unplug the Ethernet cable from the radio and plug it into the next radio to be
configured.
8
Set Up a Repeater. (page 20) Return to the RLX-IH Browser. To be sure that
you are seeing the latest status of the radio(s), go to the toolbar (page 73)
and click the "Clear" icon (eraser) followed by the "Scan" icon (binoculars).
Double-click the listing of the next radio to be configured, and configure it as
a repeater radio.
9
Save the Radio Configuration. (page 19) Save the repeater radio settings by
clicking Apply Changes at the bottom of the Radio Settings screen. Repeat
steps 7 through 9 to configure each repeater in the network.
10
After configuring the network and its radios, physically label each radio.
Labeling eliminates confusion about which radios correspond with which
radio configurations in the software. You should identify the radio's name,
network SSID, and IP address, if set.
11
Install the radios and antennas (page 23).
The remainder of the topics in this section describe each of these steps in more
detail.