Module Configuration
MVI46-GEC
♦
SLC Platform
Generic ASCII Ethernet Interface Module
ProSoft Technology, Inc.
Page 27 of 78
April 30, 2008
2.5.4 Connection Close Type
0, 1 or 2
This coded parameter defines the personality of the server after a connection is
made. If the parameter is set to 0, the socket will only be closed when a request
from the client is received or the connection timeout is exceeded. If a value of 1
is selected, the server will close the socket after it transmits a single message. If
a value of 2 is selected, the server will close the socket after it receives a
message.
2.5.5 Swap Rx Data Bytes
Yes or No
This parameter determines if the data received by the server will have the byte
order of the data swapped. If the parameter is set to No, no byte swapping will
occur. If the parameter is set to Yes, the odd byte will be swapped with the even
byte in each word of data received.
2.5.6 Swap Tx Data Bytes
Yes or No
This parameter determines if the data to be transmitted by the module will have
the byte order of the data swapped. If the parameter is set to No, no byte
swapping will occur. If the parameter is set to Yes, the odd byte will be swapped
with the even byte in each word of data received.
2.6 Ethernet
Configuration
Use this procedure to configure the Ethernet settings for your module. You must
assign an IP address, subnet mask and gateway address. After you complete
this step, you can connect to the module with an Ethernet cable.
1
Determine the network settings for your module, with the help of your network
administrator if necessary. You will need the following information:
o
IP address (fixed IP required) _____ . _____ . _____ . _____
o
Subnet mask
_____ . _____ . _____ . _____
2
Gateway address
_____ . _____ . _____ . _____Click [+] to expand
the tree for the MVI46-GEC module.
