ProSoft Technology BM GM1K Series, Руководство пользователя

Страница: 33 / 101

Installation
ProSoft Technology, Inc. Page 33 of 101
January 8, 2018
5) Where bulkhead (black phantom) antennas are used, the inner surface,
outer surface, and inner wall of the hole drilled, should be isolated from
the antenna. Use the rubber washers supplied by manufacturer to isolate
the antennas from the enclosures (use thickest washer supplied by
manufacturer to isolate the antennas from the enclosures (use thickest
washer on exterior side of enclosure).
6) Install antenna and connect all cables
7) Must install omni or bulkhead antenna in upright position
Do not mount sideways!
4. Attach I/O Module(s) to the system.
a. Place Modules in any combination (do not leave gaps between Modules).
b. When using more than five (5) I/O Modules, determine maximum I/O
Module combination by using power budget calculator found at:
http://psft.com/BLJ
WARNING: Power must be disconnected prior to attaching or removing any I/O Modules from the
system – failure to comply may cause damage to the I/O Module(s).
c. Then, use the 16-position Switch located on the front of each I/O Module
to set device ID(s). Each of the Modules must be set to its own ID for the
system to function properly. Enter this ID when configuring that Module in
the Wireless I/O Designer software.