•
5
•
10. ASSEMBLY INSTRUCTIONS
10.1
It is important to fully assemble your charger before use. Remove all cord wraps and uncoil
the cables prior to using the battery charger. Follow these instructions.
PARTS
TOOLS NEEDED
(2) 10-32, thread cutting screws
(2) 10-24 x 5/8” thread cutting screws
(2) wheels
(1) axle
(2) axle caps
(2) axle brackets
(1) handle
(1) foot
3/8" wrench (for mounting foot)
5/16" wrench (for mounting wheels)
1/4" wrench (for mounting handle)
hammer
flat-head screwdriver (not included)
Phillips-head screwdriver (not included)
10.2 Attach the foot:
Remove the charger
from the packing materials and place
upside down on
a flat surface.
Attach the foot
and secure it with
the two 10-24 x
5/8” thread cutting
screws provided.
10.3 Assemble the wheels and axle:
Hold
the axle upright on the floor or work
surface. Then, using a hammer, tap
one of the axle caps onto the top end of
the axle. Be sure to tap the axle cap on
straight. Slide both wheels onto the axle
with the recessed hubs facing out as
shown. Install the second axle cap.
1
2
3
4
5
6
1
2
3
4
5
6
10.4 Mount the axle to the charger:
Place
one end of each bracket into the slot on
the bottom of the charger. Place the axle
assembly under each bracket. Attach
the brackets using the two 10-32 thread
cutting screws provided.
NOTE:
Be careful not to drop the
brackets inside of the charger case.
1
2
3
4
5
6
1
2
3
4
5
6
10.5 Attach the handle:
Turn the charger
right side up onto its foot and wheels.
Remove the two top screws from each
side of the charger. Align the
handle, so the screw holes
are aligned with the screw
holes on each side of
the charger. Attach
the handle, using
the same screws
you previously
removed.
11. CONTROL PANEL
CHARGE RATE SELECTION
TOGGLE SWITCHES
Use the charge rate selector switches
to select the charge rate or engine start
setting.
• Switch #1 –
Use this switch to select the
200 Amp Engine Start and the 35 Amp
Charge Rate. Switch #2 must be in the
down position (Select Position) when
using Switch #1.
• Switch #2 –
Use this switch to select
the 2 amp Charge Rate and the OFF
position. Also, use to select use of
Switch #1. Note that Switch #1 is only
effective when Switch #2 is set to
“Select Position.”
1
2
3
4
5
6
1
2
3
4
5
6
