•
4
•
FEATURES
5
2
4
3
1
6 7
1.
Jump start ON/OFF switch
2.
Work light
3.
Digital display
4.
Two 12V DC power outlets
5.
Battery clamps and cables
6.
Main power switch
7.
USB port
CHARGING THE INTERNAL BATTERY
IMPORTANT!
CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE,
AND EVERY 30 DAYS TO KEEP THE
JUMP STARTER’S INTERNAL BATTERY
FULLY CHARGED.
CHECKING THE LEVEL OF THE
INTERNAL BATTERY
To check the internal battery’s charge
status, toggle the Light/Percentage of
Charge switch to the Percentage of Charge
position. The digital display will show the
battery’s percent of charge. Charge the
internal battery if the display shows it is less
than 100%.
NOTE:
Internal battery’s percent of charge
is most accurate when the jump starter has
been disconnected from all devices and
charging sources for a few hours.
CHARGING THE INTERNAL BATTERY
1.
To charge, plug an extension cord into the
charger port on the back of the jump starter.
2.
Plug the extension cord into a 120V AC
electrical wall outlet. The green LED on
the back of the unit will light whenever a
cord is plugged into the charger port.
3.
While the jump starter is charging, you
can monitor the progress of the charge by
pressing the percent of charge switch on
the front of the unit. When fully charged,
the display will show 100. Complete
charging may take up to 72 hours. The
jump starter is then ready to use.
4.
The charger will automatically go into
maintain mode and maintain the battery
at full charge without damaging it.
5.
Charge the jump starter as soon as
possible after use.
IMPORTANT:
Do not use the jump starter
while charging the internal battery.
CHARGING THE INTERNAL BATTERY
WHILE DRIVING
You may also charge the internal battery while
driving, using a male-to-male charger cable
(part number 94500109 – not included).
IMPORTANT:
DO NOT CHARGE THE
INTERNAL BATTERY FOR MORE THAN
30 MINUTES OR LEAVE THE BATTERY
UNATTENDED. IT COULD EXPLODE,
CAUSING PROPERTY DAMAGE OR
PERSONAL INJURY.
1.
Make sure the car is running.
2.
Insert one end of the accessory cable into
the 12V DC power outlet.
3.
Insert the other end of the accessory
cable into the vehicle’s accessory outlet
(lighter socket).
NOTE:
Using this method to charge the
battery overrides the maintain mode and the
battery can be overcharged. Monitor the
progress of the charge by pressing the
Percentage of Charge button on the front of
the unit. Do not leave the battery
unattended or it could explode, causing
property damage and personal injury. When
the battery is fully charged, disconnect the
accessory cable from the jump starter, and
then from the lighter socket of the vehicle.
NOTE:
Completely disconnect the charger
cable when the engine is not running.
