background image

16. 

Surge flushing: It is important to surge flush the 

SYSTEM 

prior to final connection/installation to 

 

household plumbing and use to prevent carbon media fines or carbon dust from discharging into 

 

the household plumbing and water appliances. 

a. 

Install temporary line at OUTLET of Sub-micron filter assembly to allow water to drain out

b. 

BYPASS LINE valve should be turned off

c. 

Slowly turn on the water supply line. You may notice discolored and or cloudy water due to carbon 

 

fines flowing into the drain. This is normal as the 

SYSTEM 

is being flushed out.  Continue to slowly turn 

 

on and flush until clear water free from discoloration and cloudiness is flowing

d. 

Once completed, disconnect the temporary line at OUTLET and finish connection/installation to the

 

household plumbing line

17. 

Make sure 

SYSTEM 

is firmly attached and supported

18. 

Once installation is complete, reinstall ElectroCharged™ Sub-micron filter cartridge into housing. 

 

Slowly turn on water supply line and press red button on filter head to release air pressure

19. 

Run system and inspect for any leaks

20. 

Should water appear cloudy in a glass, this is normal as there maybe air bubbles still in the system 

 

and will dissipate with use

MAINTENANCE

1. 

USE OF BYPASS LINE: BYPASS LINE is intended to be used when circumventing the system for 

 

maintenance or repair of 

SYSTEM

.  To use, 

 

 

a. 

Shut off the main supply line and open faucet to release pressure

 

 

b. 

Close the INLET and OUTLET valve and open the BYPASS line valve

2. 

ElectroCharged™Sub-micron filter cartridge replacement – recommend every 6 months or;

 

 

a. 

Should there be a noticeable reduction in water flow, change in taste or if the filter  

 

 

 

cartridge becomes heavily discolored, indication the Sub-micron filter cartridge    

   should 

be 

replaced.

  b. 

Replacement 

instructions

 

 

 

i. 

TURN OFF MAIN WATER SUPPLY, INLET and OUTLET WATER VALVES 

 

 

 

ii. 

Place a bucket under the filter housing assembly to catch excess water

 

 

 

iii. 

Relieve water pressure by pressing red button on Sub- micron filter assembly  

    head

 

 

 

iv. 

Unscrew clear housing sump using supplied wrench and slowly turn to the left 

 

 

 

 

until sump is detached from assembly head. Discard old filter cartridge. Wash  

 

 

 

 

sump thoroughly with mild soap and water. Rinse well. DO NOT place in   

    dishwasher.

 

 

 

v. 

Remove and lubricate O-ring with food grade oil

 

 

 

vi. 

Insert new cartridge and re-install sump housing. Be sure O-ring is positioned  

 

 

 

 

correctly in the proper groove before tightening onto the head. Tighten using  

 

 

 

 

supplied wrench only. Caution not to overtighten as damage and or leakage  

    could 

occur. 

 

 

 

vii. 

Slowly turn on main water supply and open INLET and OUTLET valves

 

 

 

viii. 

Press red button on head to release air pressure and check for leaks

 

 

 

ix. 

Flush system for several minutes. 

 

 

 

x. 

You are now ready to use.

3. 

Manufacturer recommends ElectroCharged™ Sub-micron filter housing assembly be replaced every  

 

4 years to maintain warranty

4. 

Use only warm, soapy water to clean the outside of the 3 stage filter tank housings. Rinse well with  

 

fresh, clean water. Never use chemical cleaning products on the filter’s housing exterior surface as  

 

this may cause damage to the housings. 

5. 

3 stage tank assembly replacement

 

 

a. 

Shut off the main water supply line, INLET and OUTLET valves

 

 

b. 

Disconnect the INLET and OUTLET side of the 3 stage tank assembly

 

 

c. 

Disconnect the ElectroCharged™Sub-micron filter assembly from 3 stage tank 

   assembly

 

 

d. 

Depending on the installation, the rack may need to be detached from the wall in  

 

 

 

order pull out (slide) the 3 stage tank assembly from the rack

 

 

e. 

Continue replacement installation with step 16 through step 20

Содержание ProMax







Отзывы: