pronovost PGS-740, Руководство оператора и каталог запасных частей

Страница: 15 / 36

- 15 -
STARTING-UP
START-UP PROCEDURES
1) Check oil level in gearbox and in speed reducer if
so equipped. Use SAE 80W90 gear box oil.
2) Check oil level in auger drive chain box . Fill to
level plug.
Use SAE 80W90 oil (Fig. 28).
3) Lubricate all points with a good quality
multipurpose grease. For the PTO tubes, use a
grade 0 synthetic grease like "Petro-Canada Arctic
Synthetic NLGI Grade 0" or equivalent.
4) Check chain take-up adjustment. The spring
maintaining the tension must be compressed to a
length between 3" and 3 1/4".
5) Verify for adequate tightness of all fastening
devices. Refer to torque chart on page 31.
6) Adjust skid shoes according to ground conditions
(Fig. 29).
7) Make sure of a 540 RPM input to your
snowblower.
8) Check impeller adjustment. The tip of the blades
should be approximately 1/8" to 3/16" from the
discharge wall of the drum. If necessary, adjust
with the take-up screws provided (Fig. 30).
5
Figure 29
Figure 30
Figure 28
Oil level
