pronovost PGS-740, Руководство оператора и каталог запасных частей

Страница: 16 / 36

- 16 -
MAINTENANCE
1) Wipe off all grease fittings with a clean cloth
before adding grease in order to avoid injecting
dirt and sand.
2) Repair or replace damaged grease fittings.
3) Lubricate all grease fittings every 8 hours of
operation.
4) Lubricate P.T.O. shaft as indicated below:
Pull out the P.T.O. And lubricate between the two
tubes with low temperature grease. Use a grade 0
synthetic grease like "Petro-Canada Arctic
Synthetic NLGI Grade 0" or equivalent. Drive line
tubes must slide easily even in cold weather. Clean
off old hardened grease and apply fresh grease as
needed.
5) Check oil level in gear box once a month. Adjust
to required oil level as per drawing in "Parts List
section".
Use SAE 80W90 oil.
6) Check oil level in auger drive chain box once a
month. Fill to level plug, figure 28 page 15. Use
SAE 80W90 oil.
7) Check tension of drive chain every 24 hours of
operation and adjust if necessary.
8) Check for tightness of bearing collars every 48
hours of operation.
9) Change gearbox oil once a year. Adjust to
required oil level as per drawing in "Parts List
section".
Use SAE 80W90 oil.
10) Change the auger drive chain box oil once a
year. Fill to level plug, figure 28 page 15. Use
SAE 80W90 oil.
11) Check all nuts and bolts once a year. If necessary
use torque chart on page 31.
12) For the auger drive shaft, always use a grade 5
shear bolt.
13) For the PTO shaft:
AT 540 RPM on a PTO size 60, the shear bolt is
10 mm, grade 8.8, part number 8218 .
14) Anti-friction slides do not require lubrification
except at the end of the season in order to prevent
corrosion of steel components that are in contact
with the anti-friction material.
6
GENERAL MAINTENANCE