Pronomic PowerMake 600, Руководство пользователя

Страница: 28 / 40

8
1 - Connection socket microphone
This connector is an XLR jack. XLR microphone cables can be connected to this
jack. When phantom power is activated, this jack is supplied with 48V phantom
power, e.g. to operate condenser microphones.
2 - Line connection socket
This connector is a 6.3mm balanced phone jack. Instrument cables can be
connected to this jack.
3 - Gain control
This control determines the signal strength of the incoming signal. Turn the Gain
knob clockwise to increase the signal strength and counterclockwise to decrease
the signal strength. For the highest quality signal processing, it is recommended that
the gain level be as high as possible. If the gain level is too high, the PEAK LED
indicator for the respective channel will light up. In this case, reduce the gain level
immediately. Please note that the PEAK LEDs should not light up during operation
to avoid noise and damage. They only help to level and readjust the signal. If a
PEAK LED lights up, reduce the respective gain level immediately.
4 - Knobs of 3-band EQ
The three EQ controls adjust the treble, midrange, and bass of the input signal. Turn
the knob from the 12 o'clock position to the left to decrease the value and to the
right to increase the value.
5 - AUX control of the respective channel strip
Turn the AUX knob clockwise to route the signal of the respective signal to the AUX
bus of the mixer. Turn the knob clockwise to increase the signal amount and
counterclockwise to decrease it. The signal is tapped in the respective channel
AFTER the respective volume control (post-fader).
Turn the knob all the way to the left if you don't want to use the AUX bus, or don't
want to feed it with the signal of the respective channel.
6 - FX control of the respective channel strip
Turn the FX knob clockwise to route the signal of the respective signal to the FX bus
of the mixer. Turn the knob clockwise to increase the signal amount and
counterclockwise to decrease it. The signal is tapped in the respective channel
AFTER the respective volume control (post-fader).
Turn the knob all the way to the left if you don't want to use the FX bus, or don't
want to feed it with the signal of the respective channel.
7 - PEAK LED
The PEAK LED indicates when the signal strength in the respective channel is too
high. Please note that the PEAK LED of a channel should not light up during
operation to avoid noise and damage. The PEAK LED only helps to level and