________________________________________________________________________________
10
–
Lift trolley Lift&Drive
325P+
On the power pack a flashing bar on the voltage indicator means that the batteries need charging.
The lift trolley will not perform a lift while the voltage indicator are flashing. If the lift trolley is left
unused for about 10 minutes sleep mode is activated and the voltage indicator turns black. The lift
trolley is restarted by pressing any button on the remote control. When the lift trolley
is restarted
from sleep mode after charging it takes about two minutes before the voltage indicator shows
fully charged. The lift trolley should not be used until the indicator on the actual charger turns
green (4-8h).
If the lift trolley is used in more than one shift per day an extra power pack per shift is necessary in
order to secure fully charged and healthy batteries. A mark-up system with numbers helps the
operators using the right power pack on the right shift and therefor avoiding damaging the
batteries permanently.
5.2
Every year, or when needed
5.2.1
Cleaning
Clean the lift trolley using detergent suitable for painted surfaces, aluminium and stainless steel.
Follow the instructions on the detergent. Wipe the lift trolley dry after cleaning. Do not use hose
or high-pressure jet as this may damage the electronics and the paint.
5.2.2
Electrical connections
Check all connections and repair any damage or wear. If needed, replace with new parts.
5.2.3
Wear of machine parts
Check the parts of the machine in order to identify any cracking or wear.
5.2.4
Nuts and bolts
Make sure all nuts and bolts are tightened.
5.2.5
Lift column
Lift the columns from the cross-member.
Clean the brush stripes and wipe the columns clean.
Remove the four corner screws at the top of each column. (Not the three in the middle)
Pull out, wipe and lubricate the lift screws with new ball bearing grease.
Put the lift screws back and tighten the screws.
Check the couplings, by making sure the sleeve and the hub located inside the columns and inside
the cross-member are intact and in working order.
Put the lift columns back and perform load test, see section
Assembly
.
