PRONAR NV161/1, Руководство оператора

Страница: 33 / 132

SECTION 2 Pronar NV161/1
│
NV161/2
│
NV161/3
│
NV161/4
│
NV161/5
2.7
•
When connecting the hydraulic conduits to the tractor, make sure that the
hydraulic system of the tractor and manure spreader is not under pressure. If
necessary, reduce residual pressure in the system.
•
Before beginning repair work on hydraulic or pneumatic systems reduce oil or air
pressure.
•
In the event of injuries being caused by pressurised hydraulic oil, contact a doctor
immediately. Hydraulic oil may find its way under the skin and cause infections.
•
Rubber hydraulic conduits must be replaced every 4 years regardless of their
technical condition.
2.1.5 OPERATION WITH PTO
•
The manure spreader may only be connected to the tractor by appropriately
selected PTO shaft recommended by the Manufacturer.
•
Before using the machine the user should thoroughly acquaint himself with the
PTO shaft Operator's Manual and adhere to the recommendations contained in it.
•
PTO shaft may be connected and disconnected only if:
PTO is disengaged,
tractor engine is switched off,
parking brake is applied,
ignition key is removed from ignition switch.
•
Before starting the tractor with the coupled manure spreader, make sure that PTO
drive in the tractor is disconnected.
•
PTO shaft must be equipped with shields. Do NOT use the shaft with damaged or
missing guards.
•
Install PTO shaft according to guidelines presented in the Operator's Manual of
PTO shaft.
•
The PTO shaft has markings on the casing, indicating which end of the shaft
should be connected to the tractor. Torque limiter (if used) or unidirectional clutch
("freewheel") must be always installed on the machine side.