PRONAR NV161/1, Руководство оператора

Страница: 113 / 132

SECTION 5 Pronar NV161/1
│
NV161/2
│
NV161/3
│
NV161/4
│
NV161/5
5.29
WARNING
Do not overfill. Too much oil may result in overheating of the gears.
In case of leakage inspect the sealing and check the oil level. Operating the gears with
low oil level or without oil may result in permanent damage of their components.
Changing oil in adapter gear (A)
Start the adapter drive and let it run for a couple of minutes (in case the
machine was not operating and the gear is cold).
Stop the adapter drive and turn off the engine of the tractor.
Prepare a container for oil. Open the filler plug (2) and the drain plug (3) on
the bottom of the central gear (option 1) or the drain plugs in three gears
(option 2) and drain oil into the container.
WARNING
When draining oil from the adapter gear with the drain plug (3) located only in the central
gear wait until all oil is drained from the side gears.
Check the drain plug seal (3), replace if necessary and close the drain plug.
Set the machine horizontally and fill the gear with gear oil up to the half of the
inspection opening (1).
WARNING
When filling the gears, gear oil should get to the side gears, therefore add oil to the
correct level stepwise, controlling the oil level periodically until it stabilizes.
Changing oil in floor conveyor drive gear (B)
NOTE
.
Changing oil in the floor conveyor drive gear is easiest with the use of an oil suction
pump.
In case you do not have any oil suction pump, it is necessary to disassemble the gear. To
drain oil, the gear can be rotated relative to the shaft, so the filler plug (2) is located on the
bottom, however this is not possible for some models and equipment options.