FastTrak TX2000™ Series User Manual
34
Windows NT4
Installing Drivers During Windows NT 4.0 Installation
1. Start the system installation by booting from the Windows NT disk:
a. Floppy install: boot the system with the Windows NT installation diskettes.
b. Floppyless install: boot from floppy and type “WINNT /B”. After files have
been copied, the system will reboot. On the reboot, press the “F6” key
when the message “Setup is inspecting your computer’s hardware
configuration…” appears.
c.
CD-ROM disk install: boot from the CD-ROM disk and press the “F6” key
when the message “Setup is inspecting your computer’s hardware
configuration…” appears.
2. When the “Windows NT Setup” window is generated, press “S” to Specify an
Additional Device(s).
3. Press “O” to select “Other” and press the “Enter” key.
4. Insert the Promise Technology
FastTrak TX2000 driver diskette into drive A: and
press the “Enter” key.
5. Choose “WinNT Promise FastTrak TX2000 (tm) Series Controller” from the list that
appears on screen, and then press the “Enter” key.
6.
The Windows NT Setup screen will appear again saying “Setup will load support for
the following mass storage devices:” The list will include “WinNT Promise FastTrak
TX2000 (tm) Series Controller”.
NOTE:
If you need to specify any additional devices to be installed, do so at this time.
Once all devices are specified, continue to the next step -
7.
From the Windows NT Setup screen, press the Enter key. Setup will now load all
device files and then continue the Windows NT installation.
8.
After a successful installation, the “SCSI Adapter Setup” box will show that the
“WinNT Promise FastTrak TX2000 (tm) Series Controller” driver has been installed.
Содержание FastTrak TX2000
Страница 1: ...Ultra ATA 133 RAID Card User Manual Version 1 3 ...
Страница 46: ...FastTrak TX2000 Series User Manual 42 ...
Страница 60: ...FastTrak TX2000 Series User Manual 56 NOTES ...
Страница 70: ...FastTrak TX2000 Series User Manual 66 ...