14
(1) Power switch– turns the power on/off.
(2) Power indicator
–
lights "green" when the power is turned
ON.
(3) Microphone (audio pickup) - speak into this
part of the microphone.
(4) Infrared signal emitter
—
the infrared signals
are broadcast from infrared signal emitter.
(5) Battery case— turn the battery case to the left
to remove it.
Two NiMH batteries are required.
(6) Charging terminal
—
charging input for charging the
batteries with the AC Adapter or the battery charger
(7) Charging indicator
—
The charging indicator provides a
"red" light to indicate the following conditions when the infra
red microphone is being charged.
◎
Off : The correct re-chargeable batteries are not
installed.
◎
Flashing slowly : Charging. (Flashing: 0.80 seconds
on/0.16
seconds
off)
◎
On : Charging is finished.
◎
Flashing quickly : Indicates an abnormality.
(Flashing: 0.16 seconds on/0.16 seconds off)
(8) External Auxiliary input terminal (on the side) - Used to connect a CD or MP3
player or other device. Allows the user to wirelessly connect a source to the system.
(9) Volume for external input (inside the battery case) - Signals from the external
input terminal are adjustable with the volume
(10) Frequency switch (inside the battery case) - Set the frequency of the infrared
wireless microphone to the desired channel.
◎
“1” = 1ch “2” = 2ch “3” = 3ch “4” = 4ch
Typcially set to ”2” for Student Microphone.
●
Uses two Panasonic NiMH AA rechargeable batteries.
●
Use the specialized battery charger or the AC adapter for charging the NiMH bat-
teries. Charging time is approximately seven hours but may vary depending on the
conditions of the battery.
1
9
7
3
4
8
2
10
5
6
Operating Controls
AEH-07