Promaker PRO-TZ2400, Руководство пользователя

Страница: 9 / 32

9
connected to power supply when
you are assembling parts, making
adjustments, installing or removing
wheels, or when not in use.
As mentioned previously your cut-off
machine has been factory assembled
and adjusted. After extended use
and wear, the wheel will need to be
replaced with a new one.
WARNING
A 355 mm wheel is the maximum
wheel capacity of your cut-off
machine. Never use a wheel that is
too thick to allow outer flange to
engage with the flats on the spindle.
Larger wheels will come in contact
with the wheel guards, while thicker
wheels will prevent the bolt from
securing the wheel on the spindle.
Either of these situations could
result in a serious accident and can
cause serious personal injury.
REMOVAL AND INSTALLATION
OF THE WHEEL (Fig. 3)
• Unplug your cut-off machine.
WARNING
Before performing any adjustment,
make sure the tool is unplugged
from the power suppl y. Failure
to heed this warning could result in
serious personal injury.
•Push down on machine arm and
remove chain from hook on motor
housing to release machine arm.
•Raise machine arm to its full lifted
position. Be cautious when raising,
machine arm is spring loaded.
•Pull lower wheel guard upward,
exposing wheel bolt that secures
abrasive wheel to wheel arbor.
•Pull the spindle lock button and
rotate bolt until spindle locks,
preventing shaft from rotating.
•Using the Wrench provided, to
loosen and remove bolt.
Note: Bolt has right hand threads.
Turn bolt counterclockwise to
loosen.
•Remove outer washer, outer flange,
and wheel. Do not remove spacer,
inner flange and inner washer.
Removal of these three parts are
not required for wheel changes.
WARNING
If inner flange, inner washer or
spacer has been removed, replace
those parts before placing wheel on
wheel arbor. Failure to do so could
cause an accident since wheel will
not tighten properly.
TO INSTALL(Fig. 3)
• Unplug your cut-off machine.
WARNING
Failure to unplug cut-off machine
could result in accidental starting
causing possible serious
personal injury.
•Inspect the replacement wheel for
defects such as cracks, chipping,
and correct speed rating. If defects
are found or the speed rating is not
greater than 3600rpm, stop using