Promaker PRO-TZ2400, Руководство пользователя

Страница: 11 / 32

11
ADJUSTING WIDTH OF CUT (Fig. 5-6)
• Unplug your cut-off machine.
WARNING
Failure to unplug cut-off machine
could result in accidental starting
causing possible serious personal
injury.
By pressing down on the machine
arm, lower the wheel and check
clearance and maximum cutting
distance (distance from adjustable
stationary vice where wheel enters)
to front of machine base slot.
Adjust if necessary. Re-tighten
depth stop bolt lock nut securely.
CAUTION
Do not start your abrasive cut-
off machine without checking for
interference between the wheel and
the machine base support. Damage
may result to the wheel if it strikes
the machine base support during
operation of the machine.
• Tighten the depth stop bolt with the
wrench provided.
WARNING
Cutting steel will cause sparks.
Do not operate in the presence of
combustible or flammable
materials. Failure to heed this
warning could result in a fire or
serious personal injury.
OPERATION
APPLICATIONS
Use only for the purposes listed
below:
• Cutting all types of ferrous metals
such as 50.8 mm (2”) x 152.4 mm
(6”) steel framing studs.
• Cutting hard metal iron stock such
as square bar stock and angle iron.
• Cutting metal tube and pipe stock.
POWER SUPPLY
Before operating your cut-off
machine, check your power
supply and make sure it meets the
requirements listed on the tool’s
data plate. A substantial voltage
drop will cause a loss of power and
machine overheating.
ATTENTION!
Through poor conditions of the
electrical MAINS, shortly voltage
drops can appear when starting the
EQUIPMENT. This can influence
other equipment (eg. Blinking of a
lamp). If the MAINS-IMPEDANCE
Zmax<0.126 OHM, such
disturbances are not expected. (In
case of need, you may contact your
local supply authority for further
information).
Common causes of power loss and
machine overheating are insufficient
extension cord size and multiple
tools operating from the same power
source.
SWITCH
• To turn your cut-off machine ON,
depress the switch trigger located in
the handle portion of the machine arm.
• To turn it OFF, release the switch
trigger.