Promac 378VTE, Руководство пользователя

Страница: 8 / 27

6
6. To assemble the drill chuck and mount it to the spindle
6-1. Use mineral spirits to thoroughly clean the drill chuck, arbor, and spindle sockets and dry all surfaces
before assembly. Follow all safety warnings on the container of the mineral spirits. Failure to clean the
mating surfaces may cause the tapered fit to loosen during operation, resulting in separation and an
unsafe condition. Figure 05, 06, 07
6-2. Use the chuck key to adjust the jaws of the drill chuck until they are inside the drill chuck body.
Figure 08, 09
6-3. Place the drill chuck face down on a workbench. The arbor has a short taper and a long taper. Place the
short taper into the socket in the back of the drill chuck and tap it with a rubber or wooden mallet, as
shown in Figure 10. If the chuck fails to remain secure on the arbor, repeat Steps 1 & 2.
6-4. Slide the arbor into the spindle socket while slowly rotating the drill chuck. The socket has a rectangular
pocket where the tang (or flat portion of the arbor shown in Figure 10) fits into.
6-5. Seat the chuck with a rubber mallet, as shown in Figure 11.
Figure 05 Figure 06 Figure 07
Figure 08 Figure 09
Figure 10 Figure 11
Wood
Tang-Side Up