Promac 378VTE, Руководство пользователя

Страница: 7 / 27

5
5. Items Needed for Set Up
5-1.The downfeed handles must be installed to operate the drill press.
To install the downfeed handles:
Thread the handles into the spindle hub, as shown in Figure 02 , and tighten.
5-2.Install the crank lever over the pinion shaft, and tighten the setscrew in the crank handle against the flat
part of the pinion shaft. Figure 03. Install the belt cover knob in its place (see Figure 03A for location).
5-3. The drill chuck attaches to the spindle by means of the arbor, shown in Figure 04. Matched tapers on the
arbor and the inside of the chuck create a semi-permanent assembly when properly joined.
Arbor
Drill Chuck
Chuck Key
Drill shifter
Figure 02
Downfeed handles
Spindle Hub
Wrench
Size 12mm
Locked to the reference line
Figure 03
Flat part
Hex Wrench
4mm
Figure 03A
Screw
Pulley Cover Knob
Figure 04