Promac 323BF-BP, Руководство пользователя

Страница: 12 / 24

12
ASSEMBLY CHART
– SANDING BELT
4 3
2
1
1. Remove the left side hex. nut and rubber roller
from shaft.
2. Place frame assembly in. tighten cap screw by
6mm hex.
wrench(Supplied)
3. Mount the rubber roller into frame assembly.
tighten hex.
nut firmly by wrench
1. Observe aluminum roller whether it's tail end is
at the right angle (90°) to the frame.
(T urn tracking knob clockwise may make the
tail end of roller upward).
2. Turn tension locking knob counter-clockwise
about 180° then turn belt tension knob
clockwise about 120° to make aluminum roller
downward and locate sanding belt on the
center of two rollers.
3. Turn belt tension knob counter-clockwise 120°
back to tie belt up.
1. Fix protection sheet by 3 screws.
2. Fix protection cover by 4 screws.
3. Fix seal plate by 2 screws.
BELT BALANCE
1. Turn tracking knob clockwise to make sanding belt
toward right side or turn counter-clockwise to make
belt toward left side. Note: It is only allowed a tiny
adjustment at each turn.
2. Rotate belt by hand. meanwhile adjust tracking
knob.
3. Control the switch for a short on/off starting with
left hand. meanwhile put right hand on tracking
knob for clockwise or counter turning till the belt
runs stably between the two rollers.
Tension
locking
Knob
Belt Tension
Knob