1
2
3
3
Adjustment Nut
Counterbalance
2
Lever- Limit Switch
Adjust Screw
Limit Switch
4
4
Friction
Screws
1
On/Off Switch Lever Installation
Remove the white-rounded lever from the plastic bag that
contains the spare fuses and spare bulb. Install the lever
onto the On /O ff switch by pressing it over the teardrop
shape toggle until it bottoms-out. The lever is designed to
fit onto the toggle with a minimum amount of force.
WARNING
Be careful not to over press the lever as you may dam-
age the switch.
Flex Arm Counterbalanced Adjustment
On / Off Switch Lever Adjustment
On / Off Switch
Rounded Lever
Light Head
Flex Arm
5
Counterbalanced Spring Tension Adjustment
If light head drifts or springs back up, the spring tension
needs to be counterbalanced. To get access to the ten-
sion nut and adjust the spring, remove the plastic bottom
cover by pulling down on the head end of arm. Pass a
flat head screwdriver through the slot on the inside of the
extrusion. Rotate counterclockwise the splined nut for a
stiffer spring and clockwise for a looser spring.
Friction Adjustment
Remove plastic bottom cover by pulling down on the
head end of the arm. Use a 9/64” Allen wrench to tighten
or loosen the two friction screws. If arm is drifting, tighten
screws. If arm movement is too stiff, loosen the screws.
Always turn both screws the same amount.
Note:
The bottom cover snaps back into place without
the use of any tools.
Auto On/Off Microswitch Adjustment
Remove plastic bottom cover by pulling down on the
head end of arm. Use a 3/32” Allen wrench to loosen
the set screw (marked “Adjust screw”). Move the screw
towards the light head to lower the position that the light
turns Off / On. Move the screw the opposite direction to
raise the On/Off position.
