ProLights Solar, Руководство пользователя

Страница: 28 / 36

SOLAR
10
Example 10 DMX channels configuration (10Ch mode)
3.4 OPERATION IN AUTOMATIC MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MODE so many times until the display shows [ P ], then press the button ENTER.
• Press the button UP/DOWN to switch between the programs ( P1 - P5 ). The unit will operate in automatic
mode.
NOTE - Programs P1 - P5 are fully pre-programmed and will not be altered by changes in EDIT mode.
3.5 DMX CONFIGURATION
SOLAR is equipped with 3 DMX configuration.
• Press the button MODE so many times until shows [4-CH], [6-CH] or [10-CH] , and press the button ENTER to
confirm.
• Press the buttons UP and DOWN to select the desired value [001-512] .
The tables on page 12 indicate the operating mode and DMX value. The SOLAR is equipped with 3 -pole
XLR connections.
3.6 DMX ADDRESSING
To able to operate the SOLAR with a light controller, adjust the DMX start address for the first a DMX chan-
nel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX channel,
adjust the start address 33 on the SOLAR. The other functions of the light effect panel are then automati-
cally assigned to the following addresses.
An example with the start address 33 is shown below:
DMX Address: 33 DMX Address: 63 DMX Address: 43 DMX Address: 53
Fig.6
DMX512 Controller
. . . . . . . . . . . .
Number of
DMX channels
Start address
(example)
DMX Address
occupied
Next possible start
address for unit No. 1
Next possible start
address for unit No. 2
Next possible start
address for unit No. 3
6 33 33-38 39 45 51
10 33 33-42 43 53 63